2" Gray Rubber Dinette Chair Caster

This listing is for one (1) piece of our 2" Gray Rubber Dinette Chair Caster. These casters are made to replace Dinette chair casters but can also be used on Office Chairs, Home and Office Equipment, Furniture, and Store Display Stand Fixtures. The Gray Thermo Plastic Rubber Non-Marring Wheels are easy to roll and protect all floors, including wood, vinyl, tile, carpet, cement, and more. The load capacity per Chair Caster is 80 lbs each, meaning that a complete set of our Upgraded Gray Rubber 4 Dinette Chair casters can support weight up to 320 lbs if your chair can support that much weight. You will need to check your chair's manual or specifications to see if the chair can handle this much weight. Use the capacity of the chair or casters depending on which item can handle less weight to be safe. Grip Ring stem casters are extremely easy to remove and install on your chairs. Simply remove the old chair casters by pulling, popping, or prying the old ones out. Usually, a good pull and the casters should pop out. To install, simply press the grip ring stem directly into the hole until the casters sit flush on the base of the casters raceway or the bottom of the stem.

• Gray Rubber - Non-Marring
• Easy Rolling
• Non-Marking
• 2" Diameter (50mm)
• 90 lbc Capacity Each
• Caster Fits most Rolling Dinette Chairs
• QTY: (1) One Piece