Flat Steel Thrust Washers | 3/4" I.D. x 1-3/16" O.D. - PACK OF 10

This listing is for a Thrust Washer also known as a Flat Steel Washer for a caster wheel with an outer diameter bore size of 1-3/16" and the washer has an inner diameter size of 3/4". This type of washer is one of the most commonly used washers used inside our 2" wide series caster wheels. This flat washer can be easily hammered or pressed into each side of the bore allowing you to hold the 3/4" ID roller bearing in place as well as the 3/4" OD to 1/2" ID spanner bushing that should be used with this washer. If you need a matching axle that coincides with the following comments above click here.

Our Thrust washers are flat steel washers that are located between the Caster Wheels outer hub of each side of the wheel. Thrust washers hold the roller bearing inside the bore of the wheel. Thrust Washers also support the axial-load or side-to-side motion on a shaft and prevent movement along that shaft. The thrust washer provides a surface on which a roller bearing is typically supported in the Caster industry. Have more questions about our Thrust Washers? Give us a call at 1-844-439-4335 Monday thru Friday between 8 am-5 pm (CST) or email us at [email protected]

Thrust washers hold the roller bearing inside the bore of the wheel
Supports the axial-load or side-to-side motion on a shaft and prevent movement along that shaft
Provides a surface on which a roller bearing is typically supported in the Caster industry

• WASHER TYPE: THRUST WASHER / FLAT STEEL WASHER
• WASHER I.D: 3/4"
• WASHER O.D: 1-3/16"
• WASHER MATERIAL: STEEL
• COMMONLY USED ON: 2" WIDE WHEELS OR WHEELS WITH A 1-3/16" INNER DIAMETER PLAIN BORE
• USED WITH: 3/4" ID ROLLER BEARING AND1/2" ID SPANNER BUSHING ALONG WITH 1/2" ZERK AXLE