Up to 350 lbs
Up to 7,000 lbs
Up to 16,000 lbs
Up to 40,000 lbs
Shock absorbing
Outdoor / rough terrain
View All Specialty Casters
Browse all specialty caster types
All measurements indicate the wheel diameter by the tread width.
The below capacity ranges indicate the working (dynamic) load that each caster will support. A safety factor should be included in your formula to determine your required load rating per caster.
W/(C-1)=R W is total weight needed to move. C is total number of casters required. R is ideal load rating, with safety factor built in. Divide the total load weight by one less caster than you will use to safely determine load rating.
Plate dimensions shown are overall mounting plate size.
When replacing existing casters, select the closest plate size and verify bolt-hole compatibility.
BHP = Bolt Hole Pattern, shown under each plate.








































Quick Specs — Furniture Casters
| Wheel Sizes | 2″ to 8″ (50–60 mm most common) |
| Load Range | 75 lb to 375 lb per caster |
| Mounts | 7/16″ grip-ring stem, swivel, brake & self-braking |
| Treads | Soft rubber, TPR, polyurethane, nylon, polyolefin (non-marking) |
| Types | Single-wheel, decorative twin-wheel, spherical ball |
| Finishes | Chrome, black, hooded |
Furniture casters add smooth, floor-safe mobility to chairs, cabinets, tables, carts, and store display fixtures. Shop by wheel size, stem type, tread, and finish. For office and desk chairs specifically, see chair casters.
Furniture casters are light-duty wheels — typically 2″ and rated 75 to 375 lb — that mount to furniture on a grip-ring stem or plate so a cabinet, table, cart, or display fixture rolls without marking the floor. Use them any time a piece needs to move for cleaning, rearranging, or merchandising.
Pick a non-marking tread (soft rubber, TPR, or polyurethane) for finished floors, and add a brake where the piece must stay put once positioned.
CasterHQ furniture casters carry 75 to 375 lb per caster. A four-caster piece therefore supports several hundred pounds, but size by load per caster and apply a 33% derate for uneven floors — on four casters, only three reliably share the load at once. For heavier cabinets and equipment, step up to low profile or plate-mount casters.
Match the caster to the piece and the floor:
Most furniture casters use a 7/16″ grip-ring (grip-neck) stem that presses into a socket — the most common furniture and chair fitment in the U.S. Measure the socket bore and depth, or the stem on your old caster, before ordering. Threaded-stem and plate-mount options are available when the piece uses them.
Single-wheel casters roll easiest; twin-wheel and ball casters trade a little roll for looks and stability. Decorative twin-wheel casters suit visible furniture and display pieces; spherical ball casters give a clean retro look and swivel in any direction. All three come in non-marking treads for finished floors.
The furniture-caster mistake we see most is stem mismatch. People buy on wheel look and forget the 7/16″ grip-ring socket — measure the bore and depth first. And on finished hardwood, always specify a non-marking tread.
Search
