Specialty Casters
Gate Casters
BBQ Pit & Smoker Casters
Keyed Drive Wheels
Drywall Cart Casters
Skid Wheels & Casters for RVs
Leveling Casters
Shopping Cart Wheels & Casters
Band Equipment Casters & Wheels
Low Profile Casters
Cart Wheels & Casters
Toolbox Caster Sets
Bakery Oven Rack Casters
Kitchen Prep Table Caster Sets
Wire Shelving Casters
Silent Glide Casters
Wheel = wheel diameter · capacity is per caster.
Caster wheel washers for rebuilding wheel hubs: flanged combo, flat thrust and steel on neoprene washers in 3/4 x 1-3/16 and 1 x 1-15/16 in, most in packs of 10.
| Washer | ID x OD | Material |
|---|---|---|
| Flanged combo washer | 3/4 x 1-3/16 in | Plastic or steel |
| Flat thrust washer | 3/4 x 1-3/16 in | Steel |
| Steel on neoprene flat washer, 10 pack | 3/4 x 1-3/16 in | Steel and neoprene |
| Combo washer | 1 x 1-15/16 in | Steel |
| Flat thrust washer, 10 pack | 1 x 1-15/16 in | Steel |
| Steel on neoprene flat washer, 10 pack | 1 x 1-15/16 in | Steel and neoprene |
From product titles and listings [S1].
The OD matches the bore of the wheel hub and the ID matches the bearing. A 3/4 in ID washer goes with a 3/4 in ID roller bearing and a 3/4 to 1/2 in spanner bushing; the 1 in size suits wheels with a 1 in bearing.
Also needed for a rebuild: wheel bearings and spanner bushings.
A flanged washer that presses into the wheel bore to hold the bearing and spanner bushing in place.
Match the OD to the wheel bore and the ID to the bearing: 3/4 x 1-3/16 in or 1 x 1-15/16 in.
The neoprene ring seals out dirt and water and keeps the washer from wearing the bushing.
