The below capacity ranges indicate the working (dynamic) load that each caster will support. A safety factor should be included in your formula to determine your required load rating per caster.

W/(C-1)=R W is total weight needed to move. C is total number of casters required. R is ideal load rating, with safety factor built in. Divide the total load weight by one less caster than you will use to safely determine load rating.

Thrust Flat Washers

Sizes: 3/4 x 1-3/16 in, 1 x 1-15/16 in

Flat steel thrust washers for caster wheels: a 3/4 x 1-3/16 in washer for 2 in casters and a 1 in ID x 1-15/16 in OD washer sold in a 10 pack. Placed on the axle beside the hub, a thrust washer keeps the wheel from grinding against the fork. Match the ID to your axle.

Thrust Washers for Caster Wheels

Our Thrust washers are flat steel washers that are located between the Caster Wheels outer hub of each side of the wheel. Thrust washers hold the roller bearing inside the bore of the wheel. Thrust Washers also support the axial-load or side-to-side motion on a shaft and prevent movement along that shaft. The thrust washer provides a surface on which a roller bearing is typically supported in the Caster industry. Have more questions about our Thrust Washers? Give us a call at 1-844-439-4335

info@casterhq.com

BHP: 1-3/4″ × 2-7/8″, slotted to 3″

BHP: 1-3/4″ × 2-15/16″ slotted to 2-3/8″ × 3-3/8″

BHP: 2-5/8” X 3-5/8” (Slotted to 3” x 3”)

BHP: 2-7/16" x 4-15/16" slotted to 3-3/8" x 5-1/4"

(3″ Wide Casters), Industry-Standard

BHP: 3-3/8" x 5-1/4" slotted to 4-1/8" x 6-1/8"

BHP: 4-1/8" x 6" slotted to 4-1/2" x 6-1/8"

View All • 21 Plate Sizes

Plate Casters

Stem Casters

Stainless Casters

Ergonomic Casters

Leveling Casters

Thrust Flat Washers

Thrust Washers for Caster Wheels